RUST GRIP® |  One-coat, patented encapsulation-interior and exterior-Rust Grip® is the one surface protection coating that also acts as a full containment covering. This moisture-cured polyurethane coating has been used successfully in the harshest environments; chemical fields, oil fields, oil rigs, and in areas that demand resistance to the corrosive effects of day-to-day exposure. Rust Grip® is tested to encapsulate toxic elements such as existing lead-based paint, asbestos and other bio-hazard materials.
Rust Grip® is easy to use and stops the progression of rust and corrosion, while protecting the substrate far longer than conventional, industrial grade rust inhibitors. With minimal preparation and no white sand blasting of the surface, Rust Grip® applies with one coat, “two applications’” and penetrates deep into and seals the pores of the surface. Within an hour of application, Rust Grip® begins to cure, pulling moisture from the air and microscopically swelling into the individual pores of the substrate as it hardens. This moisture absorption anchors the coating and seals against any possibility of outside air, moisture or minerals attacking the surface and causing further corrosion or penetration of any kind.
| Rust Grip® is tested to encapsulate:
- Rust
- Asbestos
- Lead-based paint
- Bio-hazardous materials
|
 Rust Grip® has the ability to protect against mold and mildew on surfaces that are prone to damage from prolonged exposure. Rust Grip® creates air unsurpassed protective surface, proven time and again through on-site evaluation and real-world applications.
| - Patented encapsulation of bio-hazardous materials
- Exceptional adhesion: ASTM 5B rating
- Surface tensile strength: 6,780+ psi
- Withstands temperature up to 6000F (3150C)
- Certified penetration of 18 layers of existing lead-based paint
- Endures 29,700 rub cycles without exposing existing lead-based paint
- Passed 2000 hour salt spray test
- Test “5” on Flame Spread (0=25 Class A)
- Meets EPA Guidelines
- Certified water barrier: ASTM D6904 and ASTM D7088
- Over 15 years of successful use on oil and pipe lines
|
 Rust Grip® can protect and seal surfaces of steel, aluminum, concrete, wood, fiberglass, and other substrates. Rust Grip® will seal out moisture and air with permanent membrane that stops penetration and deterioration, blocking chemical pollutants that cause corrosion and deterioration.
| Rust Grip® is reviewed and approved by these organizations : | | - US Coast Guard | - ABS (American Bureau of Shipping) | | - University of Kentucky | - Tennessee Dept. of Transportation | | - DNV (Det Norske Veritas) | - Louisiana Dept. of Transportation | | - USDA Product Safety Branch | - Georgia Dept. of Transportation | | - IMO (International Marine Organizations | | |  |
|
